Snake Bite(tm) Spec Sheet

Snake Bite™ Application Form
Please provide the following information as completely and accurately as possible.
For any answer of "Other" please describe in the blank space that follows it.

Personal Information (Name, Email, Phone, & Address are required information)

Last Name: First Name: Email: Telephone 999-999-9999:

Address-1: Address-2: City: State: Zip:

Member Of DynoBob's Forum?: Yes No How Did You Hear About Us? Please Explain:

Forums Screen Name: Today's Date mm/dd/yyyy:

Vehicle Information

Vehicle Make: Model: Year: Engine Size: Mileage: RPM: Max

Supercharger Application: Currrent RWHP: Current Torque: Current Boost:

Supercharger Make/Model: Pulley Size: Upper in Lower lbs

If supercharger was previously ported - Porting Stage and By Whom:

Tuning Device - Make & Model: Tuning Shop - Name & Location:

CAI Make: Model: Style: OEM Under-Hood Straight Shot Fender Well Shrouded Unshrouded

Throttle Body: OEM Other Size: Single-Blade Dual-Blade

MAFF: OEM Extender Other (state make and size)

Inner Cooler: OEM Other After Cooler: OEM Other With Fans? Yes No

Exhaust Specs: OEM Headers: Mid Length Long Tubes Tube Size: Other - Describe In Detail

Converters: OEM Hi Flo Cat Delete Exhaust Tube Size: 2in 2.5in 3in Other

Cross Pipe: X H None Muffler Brand: Muffler Type: Straight Baffled

Transmission: Manual Automatic Clutch: OEM Other (Make/Model)

Flywheel:OEM Aluminum Steel Rear-End Ratio:OEM 330 355 373 411 456 Other

Fuel System: Injectors:OEM Other Lbs/Hr Fuel Pumps: OEM Other

Fuel Type: 91-Octane 93-Octane E-85 Race-Gas Octane Rating: Octane Boost Spark Plug Brand/Type/Gap:

BAP: Yes No Upgraded Fuel Lines/Rails: Yes No Nitrous System: Yes No If "Yes" - Amount:

Additional Comments or Information:

If yours is an OEM engine, no further information is needed. Please double-check your entries above and skip to the Submit button below. Otherwise, please complete the following:

Special Engine Information:

Engine Make: Engine Year: Engine Cubic Inches: Compression Ratio:

Cylinder Head Porting: Stage-1 Stage-2 Stage-3 None

Cylinder Flow Data: 25" Water 28" Water

.200": Intake: Exhaust: .300": Intake: Exhaust:
.400": Intake: Exhaust: .500": Intake: Exhaust:
.600": Intake: Exhaust: .700": Intake: Exhaust:
.800": Intake: Exhaust: .900": Intake: Exhaust:

Camshaft Information: Hydraulic Roller Solid Roller

Advertised Duration: Intake: Exhaust: Duration at .050: Intake: Exhaust:

Lobe Lift: Intake: Exhaust: Lobe Separation: